Instructions for How to Use the Mega Blaster Confetti Launcher

Step 1: Push lifting foam into the bottom of the launcher.

Step 2: Pour contents of bag into launcher (one per shot)

Step 3: Place the cardboard compression cap over the mouth of the barrel.

Step 4: Using the launcher tape, the a 5” – 6” strip and tape around the outside diameter, being careful to tape smoothly so there are no air bubbles. DO NOT tape across the top of the cap.

Step 5: be sue the lever on the trigger is in the (horizontal) position. Insert 1- 8 or 16 gram threaded Co2 cylinder into the brass-piercing unit at the bottom of the launcher barrel and screw it in until it tightens. Keep turning until it is totally tight. You may hear gas releasing as you screw in the Co2. If you do, continue screwing the cup until it is tightly screwed in and no Co2 is being released. The Co2 will feel cold once it is tightly screwed in.

Step 6: Insert the barrel into the silver quick connect and push it down as far as it will go then locak the lever down. Now it’s ready to fire.

Step 7: Insert the launcher up and at a slight angel (If you are firing CORKSCREWS aim the launcher straight up in the air to get the correct spiraling effect) Quickly pull lever down to the perpendicular position.

The confetti will discharge out of the launcher into a wonderful display of color and fun! Thhe Co2 cylinders will ice over upon discharge.

CAUTION – DO NOT AIM OR POINT THE LAUNCHER BARRELS AT ANYONE.

Check out all our great products at www.flutterfetti.com
Email: fettilady@flutterfetti.com
TO ORDER: Contact the Flutter FETTI FUN FACTORY
PHONE: 1-877-321-1999

Return Address
FLUTTER FETTI FUN FACTORY
9219 133rd AVENUE NORTH
UNIT 1E
LARGO, FL 33773